The cardboard - feeding part of the stitcher machine counts by itself, and sends a bundle to be wrapped after it arrives. Man-machine control, easy to control, can show the circuit formation fault location, convenient maintenance. After the stitcher wire is used up, the stitcher wire twisted automatic alarm system, to avoid the defective goods formed when the stitcher wire is missing and less stitcher. After the self-counting, the number of finished products can be stacked according to the preset number to the end of the conveyor, more convenient bandaging. Only two people control the placement of semi-finished products from napping to finished products, and the control is simple and convenient.
The stacking position of stitcher machine is composed of counting, stacking and sending out. In the production process will produce a little situation, especially the stacking position, often there will be inaccurate quantity or cardboard jam problem. After the carton is folded and nailed, the carton is sent to the silo by the bottom stacking feeding device. Then the number of boxes of each bundle is selected and the carton is sent out by the sending device to complete the counting and stacking operation. The structure of this kind of equipment is relatively simple, if the quality of processing problems occur, you can carry out reasonable adjustment and improvement according to the observation and check, you can improve the work efficiency and quality.
1. Inaccurate counting
First of all, check whether the timing of the counter and the delivery device is exact, and whether the carton is rolling, deflecting and out of sync in the folding process. The adjustment of the bottom stacking feeder should be in the principle of ensuring good feeding, so that the inclination is as small as possible. The number of cartons in the silo and each bundle must be properly adjusted. In order to ensure the alignment of the cardboard, the spacing between the front support plate and the push-alignment device should be a few millimeters smaller than the height of the slot.
2. The stack is skewed
In order to keep the cartons in a reasonable position in the bin of the stitcher machine to ensure normal delivery, it is necessary to adjust the pressure at the stitching and bonding of the cartons. Considering the different size and style of the carton, it is determined to be pressurized in one place or two places. The timing speed of the air pressure supply and ejector should be appropriate. If the carton is pushed up too fast, the output of each bundle is skewed, it is necessary to check whether there is obstruction in the channel, the roller is not stuck, and reasonable adjustment.